Skip to main content

DD104 Dough Processor: Quick Start Guide

Here is how to get your DD104 Dough Processor into production as quickly as possible!

Step 1: Uncrate and unload the machine

remove side wall, remove banding and blocking and take DD104 out of crate

Step 2: Inspect the machine for obvious damage from shipment

  1. If the machine has damage, let the freight carrier and Blue Line Equipment know ASAP

Step 3: Read the safety section of the Operations Manual that is included in the crate to ensure safe practices!

Step 4: Move the DD104 to its production location in the store

  1. The spot chosen should be level and have access to a standard 15A NEMA 5-15 110v wall outlet

Step 5: Disassemble, clean, and reassemble the DD104 Dough Processor

  1. Follow the Disassemble for Cleaning video accessible via the QR code on the right side of the DD104 for step-by-step instruction
  2. Reassemble the DD104 in reverse order to Disassembly for Cleaning video
  3. Operators may also find it helpful to reference the Disassembly/Re-Assembly training guide, included with the DD104 (image below)
  • InSitu recommends lubricating the top of the dough block/inside of dough pocket (green in picture above) and top and bottom of knife (yellow in picture above) with standard vegetable oil prior to use and after each cleaning. Sides do not need lubricated. Apply the oil via squirt bottle, brush, or hand.

Step 6: With the DD104 fully re-assembled, turn on the machine and perform the following checks for proper function

  1. The control screen should turn on and display the home screen (image below)
  • The air compressor should immediately turn on – the operator should hear this
    • If the air compressor does not turn on, ensure the compressor is reset by emptying the compressor tank and ensure the red on/off switch is in the “on” position.  Lift off front lower panel to access air compressor.

Step 7: Place oil on shelf and prime oiler

  1. Place oil container on shelf and insert wand (image below)
  • Insert a pan into the machine to catch any oil that sprays out during priming
  • Select the “Next” button on the home screen and then select “Prime Oil” on HMI screen to prime the oiler for production – there should be oil in the pan if oiler is fully primed.  If there is no oil in the pan, press “Prime Oil” button again.

Step 8:  Run the first batch of dough!

  1. Refer to the “Running a Batch” training video or the Operations Manual for guidance on operating the DD104